View Single Post
Old November 9, 2014, 09:20 AM   #15
Three44s
Senior Member
 
Join Date: December 15, 2008
Posts: 108
+1 on the past advice and in particular, cryogenic419's

I also took a fine sand paper to my eject tab under the shell plate.

Some of my shell plates worked from the get go and others required some breaking in ....... basically involved just going slow for a few rounds until the few wiskers from machining wore off.

Just be very light on sanding your eject tab .......

Three 44s
Three44s is offline  
 
Page generated in 0.03807 seconds with 8 queries