View Single Post
Old August 19, 2011, 12:34 AM   #3
NWPilgrim
Senior Member
 
Join Date: September 29, 2008
Location: Oregon
Posts: 2,340
The above is pretty standard way of doing it. Clean the grime off then decap and resize.

However, I prefer to use a universal decapper first (does not contact sides of case, just decaps). Then wash in detergent and vinegar, rinse, dry, resize, and tumble with corncob and carnuba wax. I do have to poke corncob out of some flash holes. These get stored until ready to use and then I just prime and load. Sounds complicated but it really takes very little time. Gets rid of the spent primer in first step so it is not dumping its crud on every thing and in the media.
__________________
"The ultimate authority ... resides in the people alone. ... The advantage of being armed, which the Americans possess over the people of almost every other nation ... forms a barrier against the enterprises of ambition."
- James Madison
NWPilgrim is offline  
 
Page generated in 0.03386 seconds with 8 queries