The Firing Line Forums - View Single Post - Can I debur the case mouth before I resize?

rwilson452 · February 6, 2005, 10:38 AM

If you don't have them already, get carbide dies.

Then clean and load. If your press allows, use 4 dies.
1) resize and deprime
2) prime (Does your press do this?) die not required
3) expand the mouth and drop powder
4)seat bullet
5) crimp

I use a Lee LoadMaster it has 5 die holes so once the press is loaded up with cases, primers, powder and bullets. After the first 4 pulls, every pull of the handle gives me another finished round. I only stop to replenish supplies in the press.

February 6, 2005, 10:38 AM	#5
rwilson452 Senior Member Join Date: June 10, 2004 Location: Tioga co. PA Posts: 2,647	loading 38/357 If you don't have them already, get carbide dies. Then clean and load. If your press allows, use 4 dies. 1) resize and deprime 2) prime (Does your press do this?) die not required 3) expand the mouth and drop powder 4)seat bullet 5) crimp I use a Lee LoadMaster it has 5 die holes so once the press is loaded up with cases, primers, powder and bullets. After the first 4 pulls, every pull of the handle gives me another finished round. I only stop to replenish supplies in the press.