The Firing Line Forums - View Single Post - Correcting the gap between cylinder and forcing cone on '51?

madcratebuilder · January 14, 2012, 07:13 AM

http://www.theopenrange.net/articles...a_Part_One.pdf
http://www.theopenrange.net/articles...a_Part_Two.pdf

The barrel lug should just contact the frame or be .001 from the frame when the arbor is bottomed out in the barrel lug. If the gap is to wide at this point then the frame and arbor require modification, and possibly the wedge slot.

January 14, 2012, 07:13 AM	#8
madcratebuilder Senior Member Join Date: November 2, 2007 Location: Northern Orygun Posts: 4,923	http://www.theopenrange.net/articles...a_Part_One.pdf http://www.theopenrange.net/articles...a_Part_Two.pdf The barrel lug should just contact the frame or be .001 from the frame when the arbor is bottomed out in the barrel lug. If the gap is to wide at this point then the frame and arbor require modification, and possibly the wedge slot.