The Firing Line Forums - View Single Post

Mike U. · November 25, 2008, 06:44 PM

It could. I just want to see how this runs first. But, that is a very good suggestion.

I just looked at re-locating the sight and I don't think it will work.
The plastic wings on the Hi-Viz sight would have to be under the barrel clamp.
As it stands now, I trimmed off enough of the sight's wings to fit around that clamp and the clamp actually restricts the movement of the sight to a degree.
The tape is essentially keeping it from popping up during recoil. I'd trimmed off just enough of the sight to have problems with it popping off using 3" magnum shells.

Also, I trimmed up the tape and re-located the sight a little further back and replaced the first pic.

November 25, 2008, 06:44 PM	#17
Mike U. Senior Member Join Date: April 2, 2007 Location: In Oz, next door to the Lollipop Guild's HQ Posts: 404	It could. I just want to see how this runs first. But, that is a very good suggestion. I just looked at re-locating the sight and I don't think it will work. The plastic wings on the Hi-Viz sight would have to be under the barrel clamp. As it stands now, I trimmed off enough of the sight's wings to fit around that clamp and the clamp actually restricts the movement of the sight to a degree. The tape is essentially keeping it from popping up during recoil. I'd trimmed off just enough of the sight to have problems with it popping off using 3" magnum shells. Also, I trimmed up the tape and re-located the sight a little further back and replaced the first pic. __________________ L'Chayim! Last edited by Mike U.; November 25, 2008 at 07:04 PM.