Thread: Sizing die
View Single Post
Old February 24, 2013, 08:04 AM   #2
Brian Pfleuger
Moderator Emeritus
 
Join Date: June 25, 2008
Location: Austin, CO
Posts: 19,578
Excessive force to get the die down?

You should be raising the ram to full height with the die backed out and no case in the shellholder and then screwing the die down until it touches the shellholder, then lower the ram and screw the die die another 1/4 turn.
__________________
Nobody plans to screw up their lives...
...they just don't plan not to.
-Andy Stanley
Brian Pfleuger is offline  
 
Page generated in 0.04053 seconds with 8 queries