View Single Post
Old April 6, 2011, 01:07 AM   #3
10-96
Senior Member
 
Join Date: October 19, 2005
Location: Tx Panhandle Territory
Posts: 4,159
I know this post is several days old, but I just saw it. I just recently replaced mine and can offer a word or two if you haven't gotten things going just yet. The locking block pin can be in any position. The retaining pin is kinda tough to get out. The ends of the roll pin were peened and masked the need to use a smaller punch. I tapped away for a while with absolutely no results, put it under a magnifyer, and realized I needed to go down in punch size.

You do know there is a Gen 3 locking block kit available directly from Beretta and Midwest Gun Works?

Good luck.
__________________
Rednecks... Keeping the woods critter-free since March 2, 1836. (TX Independence Day)

I suspect a thing or two... because I've seen a thing or two.
10-96 is offline  
 
Page generated in 0.02465 seconds with 8 queries