View Single Post
Old April 2, 2011, 12:54 PM   #1
riverwalker76
Senior Member
 
Join Date: February 13, 2010
Location: Kentucky
Posts: 993
Beretta M9 Barrel Replacement Help Needed

I have a new barrel for my Beretta M9, and am in the process of installation.

I removed the Locking Block without any problems. However, I cannot get the Locking Block Plunger Retaining Pin out. I have the correct size punch, and have tried punching it in several different directions using a brass hammer, but can't get it to budge.

Are there slots in the Locking Block Plunger that only allow the pin to be removed if the Plunger is in a certain position?
__________________
Admiral Isoroku Yamamoto - “You cannot invade the mainland United States. There would be a rifle behind each blade of grass.”
riverwalker76 is offline  
 
Page generated in 0.03683 seconds with 8 queries