[243winxb]

(You don't have to always full-length size for break-action guns.... I treat my Encore Pro Hunter just like a bolt gun.

"For Auto, pumps, levers, break actions, always full length resize."

"Always"? That's a loong time!

Q. I see a Small Base Die Set listed for my caliber. Do I need these or should I buy a Full Length Die Set or Neck Die Set? How does each set differ?

A. The Small Base Die set is intended for use for ammunition to be used in auto, semi-auto, and lever action rifles so that the loaded round chambers and extracts easily. The Small Base Sizer Die sizes the case from the shoulder to the head of the case a couple of thousandths smaller than a Full Length Sizer Die. In certain calibers it also sets the shoulder of the case back a thousandth or two more than the Full Length Sizer Die. The Full Length Die Set or Neck Die Set is not normally recommended for ammo to be used in auto, semi-auto, or lever action rifles. The Full Length Die set is recommended for ammunition used in bolt action rifles, particularly for ammunition to be used for hunting. The Neck Die Set can also be used to produce ammunition for use in bolt action rifles. The Neck Sizer Die sizes only the neck of the case so it will hold the bullet firmly. It does not size the body of the case nor does it set the shoulder back. Neck sized cases will usually chamber for three or more firings, depending on the powder charge and chamber dimensions. However, over a period of time, a slight drag will be noticed when the bolt is locked. At this point, cases will need to be full length sized and the shoulder set back so they will chamber and extract easily.
What RCBS has posted, is what i tell new people just starting to reload. I know from experence that standard dies will load most all firearms, evem M16A1. And yes, neck sizing will work for 1 loading in a machine gun. Others that are neck sizeed will soon or later need FL sizing.