View Single Post
Old December 8, 2005, 03:06 PM   #10
Old Dragoon
Senior Member
 
Join Date: October 31, 2005
Location: The Republic of Californi
Posts: 581
RK,
I think the star is ok and that is glare in the picture. The broken locator pin in the front of the frame can be drilled out carefully and possibly a small hole drilled into the pin and use an easy out to remove it, find piano wire the sma dia or a bit bigger, cut to length and replace, and peen with a punch the nipples look great, but the safety buttons look like a couple have been dry fired upon. I cannot see the hammer well either, pehaps a 3/4 view(twit the gun a bit from this position(picture of hammer) and shoot again. . . You didn't say if you had shot this piece, how does the cylinder turn, lockup etc.
If there is a cut in the hammer it can be welded up and ground back to shape.
Hope this helps.

OD
Old Dragoon is offline  
 
Page generated in 0.03463 seconds with 8 queries