The Firing Line Forums - View Single Post - mp-44

Badger Arms · February 2, 2002, 12:51 PM

My Father used to spend hours making specialty ammunition in the Garage. I remember that when it first came out, the 44 AutoMag was expensive to shoot. Heck, it's only a cut-down and then trimmed .308. All you have to do is cut down and trim any standard based round and then run it through a few sizing dies to form the cases. I'd think that brass for the MP-44 would be fairly easy and cheap to make.

February 2, 2002, 12:51 PM	#4
Badger Arms Senior Member Join Date: July 2, 2000 Location: Harnett County, NC Posts: 1,700	My Father used to spend hours making specialty ammunition in the Garage. I remember that when it first came out, the 44 AutoMag was expensive to shoot. Heck, it's only a cut-down and then trimmed .308. All you have to do is cut down and trim any standard based round and then run it through a few sizing dies to form the cases. I'd think that brass for the MP-44 would be fairly easy and cheap to make. __________________ We may or may not worship God, but John Moses Browning made sure we can choose.