Thanks for that...
The two sets of SAE I went through (one L shaped and the other 1/4" drive) had nothing that would fit and were not marked...That was why I used the metric sizes I knew were hi/lo...
I just had a brainstorm and found a work-around...
It is not 'right', but it did work slick...
I tried my Torx set, and indeed one worked perfectly with no slip or marring...
I used the T-15 size, and it inserted snugly to the base of the hole, and turned the screws beautifully...
Thanks again!
Last edited by Salmoneye; February 10, 2012 at 03:14 PM.
|