View Single Post
Old August 22, 2011, 08:48 AM   #4
oneounceload
Junior member
 
Join Date: April 18, 2008
Location: N. Central Florida
Posts: 8,518
Quote:
DISASSEMBLY
Place the shotgun on safe and ensure that it is completely unloaded.1.
With the bolt closed, unscrew the forend cap 2. ( FIG.13a & 13b).
Then carefully remove the barrel. The gas piston slides off the front of the magazine cap shaft ( FIG.14 ).
Using the ring of an empty shell, carefully pry the cocking handle out and remove it as show 3. in FIG.15. Remove the action bar bolt group assembly ( FIG.16 ). Bolt, action bar and recoil spring being removed from the receiver by being slid down the magazine tube ( FIG.17 ).
With a pin punch tap out the two trigger guard pins 4. ( FIG.18 ).
The trigger group can be removed by pulling outward ( FIG.19 ).
That's from the page before - IIRC, it is page 5 in the XLR manual past the Italian language part
oneounceload is offline  
 
Page generated in 0.03222 seconds with 8 queries