Thread: Reloading
View Single Post
Old February 9, 2013, 06:36 PM   #28
Nathan
Senior Member
 
Join Date: July 1, 2001
Posts: 6,285
Hmm interesting comments about the reloader/handloader type. While I agree that my aptitude and engineering background help, but are not a requirement.

One issue I see talked about a lot is production rate. Ime, this is a risky deal. Too slow, and you never develop a groove. The groove is required to make your best quality. Too fast and you are constantly fighting the primer feed, case feed and getting the powder charge looked at. I'm not sure what I need to do to make 500 rounds an hour, but I can make 200 good ones and load them on stripper clips in an hour. I could probably do close to that on a turret.
Nathan is offline  
 
Page generated in 0.02681 seconds with 8 queries