View Single Post
Old December 18, 2009, 06:48 PM   #10
machworx
Junior Member
 
Join Date: December 18, 2009
Location: Jupiter Fl, not the planet!
Posts: 3
Questions about barrel removal

Concerning the above I don't have a hyd. barrel vise would a large 3 jaw lathe chuck w/ aluminum shims to avoid scratching barrel work? Why does Harry Bonar use a one inch solid steel bar after the gun is disassembled and put it in the frame against the rear of the barrel, kind of lightly bump it? Is it to sorta just break it loose? When reassembling is it acceptable to loctite the barrel back in to keep it from loosening during firing?
machworx is offline  
 
Page generated in 0.02689 seconds with 8 queries