Thread: Firing problem
View Single Post
Old December 6, 2000, 02:58 PM   #2
Dave McC
Staff In Memoriam
 
Join Date: October 13, 1999
Location: Columbia, Md, USA
Posts: 8,811
This might seem a silly question, but did you disengage the safety?

On the shell you tried to fire, were there any marks on the primer?

Did you try other shells?

If there are no marks on the primer, the safety was off and no shell fires, my guess is there is a problem that should be covered under warranty, probably the firing pin. Take it back(after unloading and checking, to where you bought it and get it fixed or replaced.
Dave McC is offline  
 
Page generated in 0.02229 seconds with 8 queries