Thread: Barrel blank
View Single Post
Old May 9, 2008, 10:18 AM   #8
brickeyee
Senior Member
 
Join Date: December 29, 2004
Posts: 3,351
Quote:
OK, Scorch, I would probably say the same thing, but if the barrel is a straight tube, there really isn't any difference, or any reason to prefer one end over the other for threading and chambering. It's going to be a heavy sucker, though.
The barrel was bored, reamed, and rifled from the same end.
Dending on how well made it is it may be more or less uniform.
brickeyee is offline  
 
Page generated in 0.03794 seconds with 8 queries