The Firing Line Forums - View Single Post - What lube is your go-to lube?

okiefarmer · January 25, 2010, 10:45 AM

Rusty,

I don't think it would be a bad thing to have, at least the LEE push through sizer anyway. LEE recommends it too, even on their TL boolits. Occasionally, if one does not get the block halves completely closed, even a few thousandths, OD can vary enough to make a bulge in the case when loading. A quick run through the "push through" would alleviate this issue.

You may not have ever had this problems. If not, it's a moot point.

January 25, 2010, 10:45 AM	#8
okiefarmer Senior Member Join Date: February 20, 2006 Location: Oklahoma Posts: 381	Rusty, I don't think it would be a bad thing to have, at least the LEE push through sizer anyway. LEE recommends it too, even on their TL boolits. Occasionally, if one does not get the block halves completely closed, even a few thousandths, OD can vary enough to make a bulge in the case when loading. A quick run through the "push through" would alleviate this issue. You may not have ever had this problems. If not, it's a moot point. Last edited by okiefarmer; January 25, 2010 at 12:41 PM.