Interesting problem with Rifle bullets.
I just got a new set of RCBS dies for my 223 and I noticed that when seating the bullet the die is shaving off half the soft point. Very cleanly! Am I doing something wrong?
I raised an empty case and then screwed the die body in until i felt resistance. Then I put a soft point in and set the seating stem in pretty much the same way. lowered the seating stem a little at a time. The first few bullets did not have any problems. But the last few did.
Any ideas?
__________________
* (Swinging club) Whack! whack! whack! *
Nope, the old nag's still dead .
(Capt Charlie)
Last edited by grubbylabs; November 28, 2012 at 12:22 PM.
|