The Firing Line Forums - View Single Post

Wyoredman · January 3, 2013, 01:27 PM

I have 1K PMC that I have loaded 4 times and they still have good, tight pockets. I think it is good bass.

FC and LC are both Federal, both good.

S&B in .223 I have never tried, but I have 300 .38 SPL S&B that have been loaded 3 times and they are still going strong, so if their rifle brass is anything like their handgun brass, go for it!

Comercial PPU that I have shot and deprimed did not have crimped pockets, so I am not sure about the previous post that said they do. I haven't reloaded any, but I have about 100 that are decapped and sized.

What is the deal with everyone saynig to use the off brand stuff for plinking? I have had very good paper punching accuracy with PMC brass at ranges up to 300 yards.

January 3, 2013, 01:27 PM	#9
Wyoredman Senior Member Join Date: September 6, 2011 Location: Wyoming Posts: 1,352	I have 1K PMC that I have loaded 4 times and they still have good, tight pockets. I think it is good bass. FC and LC are both Federal, both good. S&B in .223 I have never tried, but I have 300 .38 SPL S&B that have been loaded 3 times and they are still going strong, so if their rifle brass is anything like their handgun brass, go for it! Comercial PPU that I have shot and deprimed did not have crimped pockets, so I am not sure about the previous post that said they do. I haven't reloaded any, but I have about 100 that are decapped and sized. What is the deal with everyone saynig to use the off brand stuff for plinking? I have had very good paper punching accuracy with PMC brass at ranges up to 300 yards. __________________ Go Pokes! Go Rams!