View Single Post
Old June 9, 2012, 07:13 PM   #8
delta tide
Member
 
Join Date: June 9, 2012
Posts: 35
Thanks for all the feed back. I researched the Lee Factory Crimp die when I was ordering all of my equipment, but decided to wait and see if I really needed it. Looks like I may add it sooner than later. For now I guess I will go ahead and shoot my reloads since they head space properly in my chamber.

Also just another piece of info. All of my brass is once fired Federal. Some of it was fired in a Beretta PX4, the rest in a friends M&P. I didn't segregate the brass from each gun, so I suspect the cases that are bulged came from just one of the guns. I'm pretty sure my PX4 chamber is fully supported, not sure about the M&P.

I'll let you guys know how they shoot when I get back to the range later next week. Again thanks for the help. I am really enjoying my new hobby so far. I look forward to chatting with ya'll some more.
delta tide is offline  
 
Page generated in 0.03062 seconds with 8 queries