[mattgreennra]

Static pisses me off more than anything. I use 2 powders, titegroup and varget in my uni-flow powder measure. The titegroup has an annoying tendancy to stick. I tried to rub dryer sheets on it or rubber band a sheet to it, but it still happened; it was probably a little less though.

I found the easiest way to remove powder that's stuck to the sides of the measure w/o compromising it is to take a kinetic bullet puller and paper towels w/o any chemicals on them. Get 2 paper towels, put the handle of the puller in the center and fold them up onto the handle. Rubber band them in place and you've got a free tool that gets the powder off the sides. This way you will have more of a "plunger" and you won't scratch up your powder measure.

powder cleaner.jpg