View Single Post
Old January 17, 2012, 10:39 PM   #16
Wayne235
Junior Member
 
Join Date: December 26, 2011
Posts: 4
scope

The barrel is drilled and tapped for the scope.
The loading tube has been turned to the side. I looked at another winchester and I could see the two groves in the tube turned to the barrel. Mine are visible because the tube is turned so the loading hole is to the side.

The loading tube is also drilled and the barrel tapped near the front site with a screw holding the end of the tude to the barrel. You can see the hole used to insert the screw in the picture.
Wayne235 is offline  
 
Page generated in 0.03120 seconds with 8 queries