View Single Post
Old May 12, 2005, 10:48 PM   #3
jonathon
Senior Member
 
Join Date: March 14, 2005
Location: Washougal, Washington. YEHAW!
Posts: 1,872
On rifles/pistols, I just set the patch on the bore, and push through with the jag. Almost never run the patch through more than once, unless its just to add lube oil.

Jag works best for the scrubbing patches, the patch puller seems to work best for lubin' since you don't drop your patch and can pull it back through.

My cleaning method is simple.. so I'll post it:

Usually take the gun apart and clean everything(saving the bore for last), depending on the gun of course.

Bore:

1. Stick the brush in solvent. Run the brush through 10-15 times depending on how much I put through the gun and the bullet(lead ones take more..)

2. Wet a patch with solvent, set it on the bore, and push through with jag.

3. Run 4-5 dry patches through

4. Repeat steps 2 and 3 till the dry ones come out clean

5. Put the patch puller on the rod, and put 2-3 drops of lube oil on the patch. Run through the bore a few times.
__________________
Romans 12:21

Do not be overcome by evil, but overcome evil with good


More CZ M52 info than you can shake a stick at!
jonathon is offline  
 
Page generated in 0.03547 seconds with 8 queries