The Firing Line Forums - View Single Post - Success with M&P trigger kit install

kahrguy · February 9, 2013, 12:55 PM

I was worried more about haveing a quality alen wrench and maybe haveing heat the set screw. But came loose easily and all went well after that. I left the stock trigger return spring in ours and ended up with a lighter trigger pull of 4lbs.

You are right say'n Glad Apex is there. Make a bad trigger pull very nice.

February 9, 2013, 12:55 PM	#8
kahrguy Senior Member Join Date: October 1, 2012 Posts: 561	I was worried more about haveing a quality alen wrench and maybe haveing heat the set screw. But came loose easily and all went well after that. I left the stock trigger return spring in ours and ended up with a lighter trigger pull of 4lbs. You are right say'n Glad Apex is there. Make a bad trigger pull very nice.