|
Okay, I'm ready to start using my Dillon to reload for rifle. Previously I've used the Dillon for pistol (with carbide dies)and my single stage for rifle. My question is what is the proper method to handle case lube on the progressive. I currently use Dillon spray on lube with the single stage, resize, wipe my cases down, and proceed with priming,charging, and bullet seating. Should I just run all cases through the progressive, and then wipe down the loaded rounds, or stop and clean each case after sizing? Also is there a better method to remove the lube than wiping each round with an old rag? Thanks,rezman
[This message has been edited by rezman (edited August 30, 2000).]
|