View Single Post
Old April 6, 2012, 10:50 PM   #5
Jim243
Senior Member
 
Join Date: January 5, 2009
Location: Just off Route 66
Posts: 5,067
A couple of points.

!. Let your scale sit for an hour before using (need to warm up the sensors)

2. Shake your powder can 10 times to make sure powder is not sticking together.

3. Wipe down your powder measure with a used dryer fabric sheet to eleminiate static cling on all plastic parts of the powder measure.

4. Do not clean the graphite off the inside of the powder measure.

5. Store your powder in a heated enviornment.

6. Turn off your heater, the fan will effect the readings on the scale, or at least make sure there is no drafts accross the scale. (AC or Heating).

7. Make sure your scale is not on your bench, it should be on a shelf by itself and make sure it is level.

Probably more but I can't think of them at this time
__________________
Si vis pacem, para bellum
Jim243 is offline  
 
Page generated in 0.03043 seconds with 8 queries