View Single Post
Old June 13, 2005, 11:59 PM   #5
Nnobby45
Senior Member
 
Join Date: November 20, 2004
Posts: 3,150
All right you guys,

settle down. To remove the slide, reach underneath and push in on the left shell stop (latch) with the left index finger. Remove fore-end, along with the bolt (while still holding the latch in) which sits on top of the slide assembly which fits on the action bars on the fore-end tube assembly.

Condensed version: Just push in on the left shell latch and the bolt will come out by pushing forward on the fore-end. The bolt will then fall out and hit you on the foot.

To assemble, set the slide assembly on the fore-end tube (it only goes one way) assembly, and set the bolt on top of it with firing pin facing forward . Start it in and push in on the right shell latch, push the bolt in slightly 'till it stops, then push in on the left shell latch. Push bolt in more. Then push in on the action bar lock (on the trigger housing) and bring the bolt to the rear all the way. Put the barrel on.

Condensed version: start it in there and push the right shell lock, push a little more then push the left one while pushing evertything in until it stops. Activate the action bar lock (bolt release) and bring bolt all the way to rear. Don't force anything. If it doesn't go, start over. Any questions?
Nnobby45 is offline  
 
Page generated in 0.02386 seconds with 8 queries