Quote:
I don't know how much loading experience you have, but that is a very common sense re-approach.
Well played.
|
Since 1982 actually.
I got the factory crimp die. I'm going to load 20 rounds and take a fine felt tip marker to trace a line around the bullet at the case mouth. I'll load 6 then fire one at a time, pulling the loaded ones after each shot to see if a gap develops between that line and the case mouth.
If I get through 20 then I'm good. If one or two start to pull I'll break them down to figure out why, which probably would be the case is slightly shorter.