View Single Post
Old February 3, 2013, 10:55 PM   #2
Dan Newberry
Senior Member
 
Join Date: October 3, 2012
Location: Wytheville, VA
Posts: 216
It might not chamber so easily... most folks shooting semi-autos give the cases a full length sizing, just to make chambering easier. That way you don't run into function issues.

I don't think .004" is out of spec, if I'm understanding you correctly. I believe the no-go gauge won't chamber until you get to .006" over SAMMI spec. And that's just the no-go... the field gauge is going to give you a bit more than that, so I believe your chamber is fine.
__________________
www.BANGSTEEL.com
Practical Long Range Rifle Courses...
Optimal Charge Weight handload consulting
Dan Newberry is offline  
 
Page generated in 0.03838 seconds with 8 queries