More like 1:30 - 2:30 O'clock for me.
Look here to see what is happening upon ejection (and also why the last round always lands slightly behind you
)
http://www.youtube.com/watch?v=PYfxzrTar0g
That said, proper ejection timing is affected by both the powder load and it's burn-rate (affecting the port pressure). QL says 42.4gr of H335 in a 30-06 case under a 150gr bullet is only 65% case fill
...
and a relatively quick burn (leading to relatively low port pressure/ejection speeds)
Try any of these loads from the NRA (Master Po) and see if your problems don't clear up:
Recommended .30 caliber M1 loadings from the NRA
http://masterpostemple.bravepages.com/M1load.htm
147 - 155 grain FMJ or HPBT bullets
IMR 3031 - 48.0 grains
IMR 4895 - 49.0 grains
IMR 4064 - 50.0 grains
W748 - 48.0 grains
AA2460 - 49.0 grains
AA2520 - 51.0 grains
AA2495 - 50.5 grains
H4895 - 49.0 grains
BLC-2 - 49.0 grains
H335 -
49.0 grains Note this runs higher chamber pressure/but also gets port pressure (& ejection speed) up).
RL-12 - 48.0 grains