View Single Post
Old April 9, 2011, 05:05 PM   #20
amamnn
Senior Member
 
Join Date: May 13, 2006
Location: WA, the left armpit of the USA
Posts: 1,323
Here are some more facts about the drawbacks of nickle plating brass--especially as pertains to rifle rounds and annealing. I was not much concerned with this article when I first read it as I did not use nickle brass in rifle rounds--but since I have been using an induction heater I have discovered that I can actually anneal certain handgun cases and when you heat nickle it becomes more brittle while the brass becomes softer--not a good situation...........anyway--read what Varmint Al has to say on the subject a couple of pages down--------->


http://www.varmintal.com/arelo.htm
__________________
"If the enemy is in range, so are you." - Infantry Journal
amamnn is offline  
 
Page generated in 0.02048 seconds with 8 queries