If commercial and/or milsurp ammunition fires reliably, and you have double-checked that the
primers in reloads are bottomed out firmly, consider also "the possibility" that you might be
oversizing the case relative to the chamber.**
If you are fully sizing (down to shell-holder and then some), can you put succesive pieces
of scotch tape on the base of case and still close the bolt?
** I realize that the extractor "should" hold the case close enough to the bolt face to prevent
movement, but if there's a little extra clearance........
Last edited by mehavey; April 9, 2013 at 09:44 AM.
|