The Firing Line Forums - View Single Post

Pahoo · December 19, 2012, 08:11 PM

bruno
It was a bit of a problem trying to follow your assembly and disassembly. Sounds like you tried to remove one too many pins or the wrong pins. You only need to push out two pins, in order to drop the trigger group/housing, out. These two pins will practically fall out. There is a bolt stop and it's the furthest pin on the back side of the reciever. That one can be hard to remove and sounds like you mistakenly removed this one and your bolt was allowed to drop down on top of the trigger housing. .....

You really don't have to send it in, just go to u-tube and your will find a ton of videos on this process. I routinely take these apart, even down to removing the safety. when i started doing trigger work on these, the first videos I looked at, were in U-Tube !! ..

Good luck and;
Be Safe !!!

December 19, 2012, 08:11 PM	#2
Pahoo Senior Member Join Date: February 16, 2006 Location: IOWA Posts: 8,783	One too many pins at a time. bruno It was a bit of a problem trying to follow your assembly and disassembly. Sounds like you tried to remove one too many pins or the wrong pins. You only need to push out two pins, in order to drop the trigger group/housing, out. These two pins will practically fall out. There is a bolt stop and it's the furthest pin on the back side of the reciever. That one can be hard to remove and sounds like you mistakenly removed this one and your bolt was allowed to drop down on top of the trigger housing. ..... You really don't have to send it in, just go to u-tube and your will find a ton of videos on this process. I routinely take these apart, even down to removing the safety. when i started doing trigger work on these, the first videos I looked at, were in U-Tube !! .. Good luck and; Be Safe !!! __________________ 'Fundamental truths' are easy to recognize because they are verified daily through simple observation and thus, require no testing.