The Firing Line Forums - View Single Post

gb6491 · November 16, 2011, 10:53 AM

Lurch37,
Your Witness Match should have an over-travel screw on the trigger: try backing it off a bit to give the trigger a little more travel (thinking that it is now adjusted to the point where it is not allowing the trigger to move far enough for correct reset of the sear/hammer).
Regards,
Greg

November 16, 2011, 10:53 AM	#8
gb6491 Senior Member Join Date: September 14, 2007 Location: Yuma county Arizona Posts: 248	Lurch37, Your Witness Match should have an over-travel screw on the trigger: try backing it off a bit to give the trigger a little more travel (thinking that it is now adjusted to the point where it is not allowing the trigger to move far enough for correct reset of the sear/hammer). Regards, Greg Last edited by gb6491; November 16, 2011 at 11:06 AM.