View Single Post
Old October 25, 2001, 08:51 AM   #9
KP95DAO
Senior Member
 
Join Date: December 30, 2000
Posts: 699
It is possible your die is out of spec. I have an old set of Redding 30-06 dies that have been around a long time and they resize on the long side. I use them to resize the brass for my NEF to prevent seperation while still getting base sizing.

You state that "your die is incorrectly set to bump the holder". It is only incorrect if that's not where it needs to be. I use a RCBS X-die to resize my Savage 10FP 308 brass and it is set against the shell holder. The headspace is perfect for my rifle.
KP95DAO is offline  
 
Page generated in 0.02848 seconds with 8 queries