View Single Post
Old January 10, 2013, 10:57 PM   #10
serf 'rett
Senior Member
 
Join Date: June 25, 2009
Location: Stuttgart, AR
Posts: 1,569
The only way I can conceive of the OAL increasing after the crimp die is if the round is being significantly resized. My concern is if the soft lead is being compressed by the FC die, while the brass springs back. Are the bullets tight in the brass? 9mm should not need a roll crimp, just remove the case mouth expansion.
__________________
A lack of planning on your part does not necessarily constitute an emergency on my part.

Last edited by serf 'rett; January 11, 2013 at 12:27 PM.
serf 'rett is offline  
 
Page generated in 0.02635 seconds with 8 queries