The Firing Line Forums - View Single Post

AZGlock13 · September 30, 2012, 12:25 AM

I bought the polished nickel SW1911 used, but what I found on the internet they appear to be the stock grips S&W put on that particular model (not too many of that model were made, as far as I can tell, but the few I seen on the Internet, have the same grips on them for that model). I have no idea what S&W called those grips. The only problem with them is that they are a bit on the slick side (not good if your hand starts getting sweaty).

September 30, 2012, 12:25 AM	#20
AZGlock13 Senior Member Join Date: May 10, 2007 Location: AZ Posts: 270	I bought the polished nickel SW1911 used, but what I found on the internet they appear to be the stock grips S&W put on that particular model (not too many of that model were made, as far as I can tell, but the few I seen on the Internet, have the same grips on them for that model). I have no idea what S&W called those grips. The only problem with them is that they are a bit on the slick side (not good if your hand starts getting sweaty). Last edited by AZGlock13; September 30, 2012 at 12:32 AM.