Lyman has a shotshell reloading book that gives you the basics.
It is really simple - you need hulls, primers, powder, wads, shot, and a way to close the hull.
Even on a basic single stage MEC, first you deprime and resize the empty hull; then you reprime the hull in the next station. Then your powder charge (determined from the powder maker charts), is placed in the hull, followed by the insertion of the proper wad (again, from the recipe) over the powder. Finally, you add the desired amount of shot into the wad where it then has the crimp started and then, at the last station, finalized. While recipes and components are more stringent than metallic in certain requirements, it is also a little less precise when it comes to things like OAL in .001 increments
|