View Single Post
Old May 13, 2012, 03:21 PM   #22
Technosavant
Senior Member
 
Join Date: May 29, 2007
Location: St. Louis, MO area
Posts: 4,040
I tend to go with CMC Powermags. Their floorplates can damage feed ramps on aluminum frames without ramped barrels (a reason I prefer ramped barrels in lightweight 1911s), but with ramped barrels it's not an issue.

I've even retrofit some iffy mags of other makers with CMC springs/followers and that cured them of their feeding problems. IMO, their follower is a very nice thing to have if you're going for that extra round in the mag.
Technosavant is offline  
 
Page generated in 0.03267 seconds with 8 queries