View Single Post
Old January 30, 2000, 03:51 PM   #2
Art Eatman
Staff in Memoriam
 
Join Date: November 13, 1998
Location: Terlingua, TX; Thomasville, GA
Posts: 24,798
A po'boy solution: Find some half-inch copper rod. Find somebody with a Unimat or better lathe.

Turn the rod to .451 or .452 and cut a 60-degree or 75-degree cone; cut off with enough straight side to seat in the .45 case. This roughly 110-grain bullet will come out of a .45ACP at around 2,000 to 2,200.

, Art
Art Eatman is offline  
 
Page generated in 0.04243 seconds with 8 queries