The Firing Line Forums - View Single Post

Jim V · December 31, 1999, 05:52 PM

When you put the new ejector in, you will notice that there is no clearance for the pin that holds it in. DO NOT install the ejector and then try to drill the new clearance slot. You will screw up the frame. Insert a small drill bit in the pin hole and work it with your fingers to mark the ejector leg. Remove the ejector and file a new notch in the leg.

Please don't ask how I know. LOL

------------------
Ne Conjuge Nobiscum
"If there be treachery, let there be jehad!"

December 31, 1999, 05:52 PM	#3
Jim V Senior Member Join Date: January 31, 1999 Location: SE Michigan - USA Posts: 4,038	When you put the new ejector in, you will notice that there is no clearance for the pin that holds it in. DO NOT install the ejector and then try to drill the new clearance slot. You *will* screw up the frame. Insert a small drill bit in the pin hole and work it with your fingers to mark the ejector leg. Remove the ejector and file a new notch in the leg. Please don't ask how I know. LOL ------------------ *Ne Conjuge Nobiscum* "If there be treachery, let there be jehad!"