View Single Post
Old August 24, 2012, 04:57 PM   #5
Slugo
Junior member
 
Join Date: September 15, 2001
Location: Central PA
Posts: 1,007
here's all I do to clean my 1100 LT-20. Like Big Jim said, I let no more than 100-200 shells ignite in the gun, then I strip and clean it immediately. It's best to shoot an 1100 semi-dry. All I do is remove the barrel and forearm, pull off the two rings and rubber O-ring. I rub off any gunk on the recoil tube with 00 steel wool and the action bar. I will then spray a little bit of G96 or Break Free CLP on the recoil tube, action bar and gas cylinder that is attached to the barrel. Then wipe everything off with a clean rag, then reassemble. Oh yes, use a pipe-cleaner to ream out the gas ports so they remain void of crud.

I only clean the trigger group once a year with a blast of Gun Scrubber. That should do it for you...
Slugo is offline  
 
Page generated in 0.02555 seconds with 8 queries