View Single Post
Old December 25, 2012, 10:58 PM   #4
jepp2
Senior Member
 
Join Date: December 24, 2008
Location: Loveland, CO
Posts: 1,476
I agree that the RCBS primer pocket uniformer isn't going to remove the crimp.

Can you post a picture of a few of the primer pockets? Nice clear close ups. It is fairly easy to see if they were crimped.

Normally when you try to seat primers in a pocket that was crimped but not swaged or reamed, you will encounter resistance since the primer catches as it should be starting into the pocket since there is no clearance provided by the radius to get the primer/brass aligned.
jepp2 is offline  
 
Page generated in 0.03377 seconds with 8 queries