View Single Post
Old January 21, 2011, 02:28 PM   #33
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 13,195
For the weight inside the stock / figure out where you want it - how deep in the cavity you want it ... and use a dowel rod / an old towel ...or whatever to take up the space in front and in back of it....so it doesn't slide back and forth - and stays precisely at the point you want it. You can tape the spent hulls together or whatever works / doesn't have to be fancy...just so it doesn't move.

ReCobs Target shop is where I buy my loaders and wads in case quantities....and they're good people.

http://www.recobstargetshop.com/index.htm

They have new Grabber models for about $ 370 ....but there are a lot of good used machines around too ...my local gun show always has some. There are cheaper models too ....but I like the capability of the Grabber ...its the low end of the Progressive machines ....but has a good resizer, etc ...and It'll give you a good 5 - 6 boxes an hour with no problem.

Bass Pro, Cabelas, etc are all fun shops to visit ...have a good time ...
BigJimP is offline  
 
Page generated in 0.02978 seconds with 8 queries