View Single Post
Old December 6, 2010, 06:57 AM   #31
Hey_Allen
Member
 
Join Date: October 14, 2008
Location: NW Washington
Posts: 39
My understanding of the graphite molds is that they're intended for the precious metals trades.

When I was looking into casting and reading up on the molds, I came across the graphite ones, but I also noticed that they were almost always built to much smaller sizes than the lead casting community uses.

When you're playing with gold or silver, and playing with materials that cost that much, apparently you don't keep all that much on hand...
Hey_Allen is offline  
 
Page generated in 0.02796 seconds with 8 queries