The Firing Line Forums - View Single Post

DennRN · April 11, 2013, 04:29 AM

Thanks for the replies,
I thought I would take the extra step of cleaning twice to keep my case feeder assembly clean and avoid cross contamination, especially since I'm eventually going to upgrade to bullet fed with case lubed MR. bullet. I'd like to do so while still maintaining speed by crank, inspect, bucket, repeat.

Sounds like the consensus is not needed?

BTW, I'm a nurse and used to work as an engineer so I can be a little "retentive" about my tools and contaminants.

April 11, 2013, 04:29 AM	#5
DennRN Member Join Date: April 10, 2013 Posts: 96	Thanks for the replies, I thought I would take the extra step of cleaning twice to keep my case feeder assembly clean and avoid cross contamination, especially since I'm eventually going to upgrade to bullet fed with case lubed MR. bullet. I'd like to do so while still maintaining speed by crank, inspect, bucket, repeat. Sounds like the consensus is not needed? BTW, I'm a nurse and used to work as an engineer so I can be a little "retentive" about my tools and contaminants. Last edited by DennRN; April 11, 2013 at 04:35 AM.