The Firing Line Forums - View Single Post

GP100man · January 24, 2012, 07:48 PM

Mike

Did ya clean all the copper out ???

How are you cleaning the lead out ???

Can ya push a bullet thru the throats ????

Is the barrel constricted where it screws into the frame ???

Last but not least do ya have another powder to try ? as I have bullets when switched to BE they lead ( I feel BE is so sooty it dries the lube in the bore)

Here`s how I delead a barrel & cyl. After an unsuccesful load It works so well I put the Lewis kit away !

Choreboy copper (all copper) pot scrubber wrapped around a brush after soaking with Ed`s Red

Chronograph ???

You may want to post this in the bullet casting section also, as there are some that shoot lead exclusively & have waded thru alot to get where they are now , me included

January 24, 2012, 07:48 PM	#4
GP100man Senior Member Join Date: August 1, 2007 Location: Tabor City , NC. Posts: 1,969	Mike Did ya clean all the copper out ??? How are you cleaning the lead out ??? Can ya push a bullet thru the throats ???? Is the barrel constricted where it screws into the frame ??? Last but not least do ya have another powder to try ? as I have bullets when switched to BE they lead ( I feel BE is so sooty it dries the lube in the bore) Here`s how I delead a barrel & cyl. After an unsuccesful load It works so well I put the Lewis kit away ! Choreboy copper (all copper) pot scrubber wrapped around a brush after soaking with Ed`s Red Chronograph ??? You may want to post this in the bullet casting section also, as there are some that shoot lead exclusively & have waded thru alot to get where they are now , me included __________________ GP100man Last edited by GP100man; January 24, 2012 at 08:05 PM.