The Firing Line Forums - View Single Post

branrot · May 15, 2002, 11:01 AM

I know I've made similar posts before, but I had a couple minor problems with my 650 when I switched over from 9mm to .38. A 2 minute phone call to Dillon got me a new microswitch and spacer for my casefeeder (I even told them I'm not sure if the spacer was never in the box or lost by me, but they didn't care and said they'd send one free of charge anyway). I also found a problem with my carbide die, and they're sending a new one out right away (I even offered to return the old one to them, but they said not to bother).

Sure, I've had a few problems, but with service like this, I'll never buy another brand. Thanks Dillon.

May 15, 2002, 11:01 AM	#1
branrot Senior Member Join Date: October 11, 1999 Location: Miami Beach, FL, USA Posts: 1,367	Dillon Service I know I've made similar posts before, but I had a couple minor problems with my 650 when I switched over from 9mm to .38. A 2 minute phone call to Dillon got me a new microswitch and spacer for my casefeeder (I even told them I'm not sure if the spacer was never in the box or lost by me, but they didn't care and said they'd send one free of charge anyway). I also found a problem with my carbide die, and they're sending a new one out right away (I even offered to return the old one to them, but they said not to bother). Sure, I've had a few problems, but with service like this, I'll never buy another brand. Thanks Dillon.