View Single Post
Old May 31, 2011, 08:16 AM   #3
MW surveyor
Senior Member
 
Join Date: May 20, 2010
Posts: 212
I'm scratching

my head over this one.

So let me get this straight. After sizing and before belling, your bullets slip inside the case? Are you sure that you are using the correct sizing die for a 38 special. I know, sounds like a dumb question but....

How much belling are you doing? Just enough to get the bullet started or something a bit more?

Are the cases all brass or something other than brass?

How about just a bit more information. I'm sure that others would also like to know more.
MW surveyor is offline  
 
Page generated in 0.04067 seconds with 8 queries